4,000 Surge Watt Dual Fuel Generator Plus Stick Welder w/CO Warning, TIG Ready

$499.99

-

4,000 surge watts / 3,500 running watts

CLICK HERE TO WATCH PRODUCT VIDEO

Run the RV, some household appliances, and power tools
Generator utilizes either unleaded gasoline or LPG propane gas a s a fuel source (propane tank not included)
7.0 HP engine, 4 stroke, 212cc, air cooled, recoil start
9 hour run time with a 50 percent load on an full 3.2 gallon gas tank, or 12 hours with a full 20 lb. propane tank
Four 120V AC outlets (each 20 amps), one 120V RV outlet (30 amps), one 12V DC outlet (8 amps) for battery charging
Less than 69 dB noise with no load at 23 ft.
Equipped with 6 ft. welding cable with electrode holder, 6 ft. ground cable with earth clamp, face mask, and wire brush

400 in stock

Description

The HIT 4000 Surge Watt Dual Fuel Generator Plus Stick Welder is TIG Ready! It has everything you need for the job in one package. A 3500 Running Rated Watts generator is combined with a 85 Amp Stick welder provides flexibility and convenience in a single unit.
First of all, it has 4,000 peak watts and 3,500 rated watts. This is a powerful Dual Fuel Generator that can handle the needs of most contractors, homeowners and recreational activities. Secondly, it is equipped with four 120 Volt outlets and a single 120 Volt RV outlet. Plus there is a 12 Volt DC outlet for battery charging. This generator can handle almost everything you need at the job site. Utilizing either unleaded gasoline or propane gas, so you can use fuel that is easily available or affordable. Finally, it provides the long lasting, clean burning advantage of propane gas.

You will find this Stick Welder is easy to use! It’s portable and is ideal for light duty welding at home, on the farm, or at the shop. For better welds and consistent output, the 85 AMP 120V welder is inverter powered from the generator. This will allow it to manage fluctuations in input power for better welding and dependability. Use 1/16, 5/64, or 3/32 inch electrodes to weld mild steel, stainless steel, cast iron, and hard surfacing.

You can use this generator during power outage, and it will help provide you with sufficient backup. Best of all, you can also use it as a welder. You will appreciate that you can transport it easily and do welding on-site. This makes it very convenient when you use it in the garage or job site.

* This generator features CO WARNING, which will automatically shut-off if dangerous levels of CO are detected. CO is commonly referred to as Carbon Monoxide. Large amounts of Carbon Monoxide can overcome you in minutes without warning — causing you to lose consciousness and suffocate. If CO detector detects increasing levels of CO gas, it automatically shuts off the engine. CO detector will detect the accumulation of Carbon Monoxide from other fuel burning sources such as engine powered tools or propane heaters used in the area of operation. After a shut-off, a blinking RED light in the CO detector badge on the side of the generator provides notification that the generator was shut off due to an accumulating CO hazard. The RED light will blink for at least five minutes after a CO shut-off.

 

Item # GEN4000DF-STW

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…